Thursday, October 21, 2010

Essential Questions

1. What is the difference between R-value and U-value? When are they used?
R-Value is the value used to indicate the resistance to the flow of heat while the U-Value is a measure of the heat transmission through a building part or a given thickness of a material with lower numbers indicating better insulating properties. To determin the amount of BTU's

2. What are some leading causes of solar gain?
Heat going through windows and doors.

3. What key areas of a building can minimize heat loss?
The walls with insulation.
4. Why is a cost estimate important to create before starting a project?
so you can expect what to pay for the project.

Essential Questions

1Why is wood so often used for residential buildings?
Cheap

2. What alternatives to wood frame construction are available and what are the advantages and disadvantages of each?
concrete -stronger

3. How are trusses able to span large distances?
cause of the triangleular shape

4. What framing systems are used to support residential roofs?
Hip roofs gable roof


5. How are different roof styles and pitches related to different architectural styles?
The type of roof depends on the type of architectual cause some astyles might have a flatt roof like international style

Monday, October 11, 2010

Key Terms 2.2

 

Compression Strength
The maximum compressive stress a material can withstand without failure.

Concrete
A solid, hard material produced by combining Portland cement, aggregates, sand, water and sometimes additional mixtures.

Design Temperature Differential
The difference between the indoor temperature in winter and the outdoor design temperature in winter. The design temperature differential or design range is used in calculating the space heating requirements of a dwelling unit under the engineering-based methodology.

Fascia
The finish board covering the edges of rafters and eaves.

Footing
The lowest, widest part of the foundation that distributes the load over a broad area of the soil.

Foundation
The lower part of a building, which transfers structural loads from the building to the soil.

Heat Loss
The energy needed to warm outside air leaking into a building through cracks around doors, windows, and other areas.

Radiant Heat
Energy radiated or transmitted as rays or waves, in the form of particles.

Rafter
Member of a roof structural frame that supports the sheathing and other roof loads.

Rebar
Steel bar used to reinforce concrete.

R-Value
The numerical value used to indicate the resistance to the flow of heat.

Sole Plate
The plate placed at the bottom of a wall.

Square (Quantity of Shingles)
In roofing, 100 square feet of roofing material.

Tensile Strength
The maximum stress a material subjected to a stretching load can withstand without tearing.

Thermal Conduction
The process of heat transfer through a solid by transmitting kinetic energy from one molecule to the next.

Thermal Convection
Heat transmission by the circulation of a liquid or a heated gas or air.



U-Factor
A measure of the heat transmission through a building part (as a wall or window) or a given thickness of a material (as insulation) with lower numbers indicating better insulating properties.

Utility Shed